Exfo FIP-400 Fiber Inspection Probe and ConnectorMax Uživatelský manuál stáhnout pdf (Strana 40)

Inspecting Fiber Ends

34 FIP-400

Inspecting Fiber Ends with the FIP Viewer

You can connect the Fiber Inspection Probe to the FIP Viewer to view and

inspect fiber ends.

To inspect fiber ends:

1. Install a probe tip (see Changing the Fiber Inspection Probe Tip on

page 13).

2. Insert the fiber into the probe tip.

3. Connect the probe to the FIP Viewer.

4. Press the On/Off button for approximately 2 seconds to turn on the FIP

Viewer.

5. Adjust the image to have the best view of the fiber end.

6. If the fiber end is dirty, remove it from the probe, clean it and

reinspect it.

7. Once you are satisfied with the inspection, go to the next fiber or turn

off the FIP Viewer.

WARNING

Never look directly into a live fiber. It could cause serious eye

damage. Always use your FIP-400 Fiber Inspection Probe.

IMPORTANT

The battery in the FIP Viewer must be fully charged before the first

use. For more information, see Charging the Battery in The FIP

Viewer on page 52.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 77 78

Žádné komentáře

Exfo FIP-400 Fiber Inspection Probe and ConnectorMax Uživatelský manuál Strana 40