Exfo FTB-500 (Window XP) Uživatelský manuál stáhnout pdf (Strana 297)

Ошибки SCPI

FTB-500 285

–312 “PUD memory lost” [Indicates that the protected user data saved by the

*PUD command has been lost.]

–313 “Calibration memory

lost”

[Indicates that nonvolatile calibration data used by

the *CAL? command has been lost.]

–314 “Save/Recall memory

lost”

[Indicates that the nonvolatile data saved by the

*SAV? command has been lost.]

–315 “Configuration memory

lost”

[Indicates that nonvolatile configuration data saved

by the device has been lost. The meaning of this

error is device-specific.]

–320 “Storage fault” [Indicates that the firmware detected a fault when

using data storage. This error is not an indication of

physical damage or failure of any mass storage

element.]

–321 “Out of memory” [An internal operation needed more memory than

was available.]

–330 “Self-test failed” -----

–340 “Calibration failed” -----

–350 “Queue overflow” [A specific code entered into the queue in lieu of the

code that caused the error. This code indicates that

there is no room in the queue and an error occurred

but was not recorded.]

–360 “Communication error” [This is the generic communication error for devices

that cannot detect the more specific errors

described for errors –361 through –363.]

–361 “Parity error in program

message”

[Parity bit not correct when data received for

example, on a serial port.]

–362 “Framing error in

program message”

[A stop bit was not detected when data was

received for example, on a serial port (for example,

a baud rate mismatch).]

Error

Number

Description Probable Cause

1 2 ... 292 293 294 295 296 297 298 299 300 301 302 ... 317 318

Komentáře k této Příručce

Žádné komentáře

Exfo FTB-500 (Window XP) Uživatelský manuál Strana 297

Komentáře k této Příručce

Související produkty a manuály pro Měřící nástroje Exfo FTB-500 (Window XP)