Exfo MaxTester MAX-630 Uživatelský manuál stáhnout pdf (Strana 35)

Setting Up the MAX-630

VDSL2/ADSL2+ Multi-play Test Set 29

Upload Setup

Ethernet Setup

The Ethernet Setup function allows you to configure

the line and access modes, etc for an Ethernet

connection, using the following parameters:

 Access Mode options are DHCP, Static, or PPPoE.

 WAN Link Speed is a choice between Auto

(negotiated during the link establishment), 100 or

10 Mbit/s.

 WAN Connect Mode is Full- or Half-Duplex,

when Link Speed is set to either 100 or 10 Mbit/s.

 VLAN Support enables the unit to tag/untag

ethernet frames.

 VLAN ID is a virtual local area network (VLAN) tag ranging from 0

through 4094. The entry is available only when VLAN Support is

Enable.

 Vendor ID is the name of the unit. This entry is available only when

Access Mode is DHCP.

 Local Mac Address is the internal MAC address of the unit: either

MaxTester or User Defined.

 Mac Address is a specific MAC address, in a hexadecimal format, if

User Defined was selected for the previous parameter. This entry is

available only when Access Mode is DHCP or Static.

The following parameters are available only when Access Mode is PPPoE.

 Login Name/Password is your user ID and password.

 Obtain IP is either Dynamic where the access concentrator or

broadband remote access server assigns a temporary IP address to

the unit, or Static where you enter the IP address of the unit.

 WAN Login Timeout is a numeric setup entry.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 134 135

Žádné komentáře

Exfo MaxTester MAX-630 Uživatelský manuál Strana 35