Exfo PM-1600 High-Speed Power Meter Uživatelský manuál Strana 120
- Strana / 162
- Tabulka s obsahem
- ŘEŠENÍ PROBLÉMŮ
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
Technical Specifications
110 PM-1600
Note: The PM-1600 High-Speed Power Meter is intended for indoor use only.
Electrical and Environmental Specifications
Operating temperature 0 °C to 40 °C (32 °F to 104 °F)
Relative humidity 0 % to 80 % non-condensing.
a
a. Measured in 0 °C to 31 °C (32 °F to 87.8 °F) range decreasing linearly to 50 % at 40 °C
(104 °F).
Maximum operation altitude 2000 m (6150 ft)
Pollution degree 2
Installation category II
Power supply rating
b
b. Not exceeding
± 10 % of the nominal voltage.
100 V to 240 V (50 Hz/60 Hz)
maximum 2 A
Technical Specifications
110 PM-1600
Note: The PM-1600 High-Speed Power Meter is intended for indoor use only.
Electrical and Environmental Specifications
Operating temperature 0 °C to 40 °C (32 °F to 104 °F)
Relative humidity 0 % to 80 % non-condensing.
a
a. Measured in 0 °C to 31 °C (32 °F to 87.8 °F) range decreasing linearly to 50 % at 40 °C
(104 °F).
Maximum operation altitude 2000 m (6150 ft)
Pollution degree 2
Installation category II
Power supply rating
b
b. Not exceeding
± 10 % of the nominal voltage.
100 V to 240 V (50 Hz/60 Hz)
maximum 2 A
- High-Speed Power Meter 1
- Contents 5
- High-Speed Power Meter v 7
- Certification Information 8
- DECLARATION OF CONFORMITY 9
- 1 Introducing the PM-1600 11
- Front Panel 12
- Back Panel 13
- RS-232 Connector Pinout 14
- 2 Safety Information 15
- General Safety Information 16
- Laser Safety Information 16
- Electrical Safety Information 17
- Power Cable 18
- 3 Getting Started with Your 19
- 10 PM-1600 20
- - - - - - - 21
- 12 PM-1600 22
- Nulling Electrical Offsets 22
- 4 Acquiring Power 23
- Measurements 23
- 1310.00 nm 24
- 1550.00 nm 24
- Measuring Absolute Power 25
- 1310.25 nm 26
- -32.218 dBm 26
- Measuring Relative Power 27
- 18 PM-1600 28
- Measuring Corrected Power 29
- Setting an Offset Value 30
- Setting Measurement Range 32
- Viewing Statistics 34
- mark is displayed 35
- 26 PM-1600 36
- Managing the Wavelength List 36
- 28 PM-1600 38
- Setting a Correction Factor 40
- Setting Display Resolution 42
- Setting Refresh Rate 44
- Setting Sampling Rate 45
- Averaging 46
- Saving a Setup Configuration 47
- 38 PM-1600 48
- Resetting the PM-1600 49
- 6 Programming Acquisitions 55
- 46 PM-1600 56
- High-Speed Power Meter 47 57
- 48 PM-1600 58
- High-Speed Power Meter 49 59
- High-Speed Power Meter 51 61
- High-Speed Power Meter 53 63
- 54 PM-1600 64
- Your PM-1600 65
- 56 PM-1600 66
- Testing Instrument Linearity 68
- 60 PM-1600 70
- Testing Repeatability 71
- Testing the Settling Time 72
- Using the External Trigger 73
- 64 PM-1600 74
- Using the Analog Output 75
- 8 Controlling the PM-1600 77
- Automatically or Remotely 77
- 68 PM-1600 78
- Communication Parameters 79
- High-Speed Power Meter 71 81
- Command Structure 82
- High-Speed Power Meter 73 83
- Error Messages 90
- High-Speed Power Meter 81 91
- PM-1600 Error Messages 92
- 9 Customizing the PM-1600 93
- Setting Display Contrast 94
- Choosing Video Mode 94
- 10 Maintenance 97
- Cleaning Fixed Connectors 98
- IMPORTANT 100
- Cleaning EUI/EUA Adapters 103
- Trigger Ports 105
- Replacing the Fuse 106
- 98 PM-1600 108
- Software Upgrade 108
- 11 Troubleshooting 111
- 102 PM-1600 112
- Transportation 114
- 12 Warranty 115
- 106 PM-1600 116
- Liability 116
- 108 PM-1600 118
- A Technical Specifications 119
- 110 PM-1600 120
- B Remote Control (SCPI) 121
- Commands 121
- 112 PM-1600 122
- General Commands 122
- 114 PM-1600 124
- 116 PM-1600 126
- FETCh[:SCALar]:POWer:DC? 128
- FORMat:READings[:DATA] 129
- INITiate:AUTOstop 130
- INITiate:AUTOstop? 130
- INITiate:CONTinuous 131
- INITiate:CONTinuous? 131
- 122 PM-1600 132
- Specific Commands 132
- READ:ALL:POWer:DC? 133
- READ[:SCALar]:POWer:DC? 133
- SENSe:AVERage:COUNt 134
- SENSe:AVERage:COUNt? 134
- SENSe:AVERage[:STATe] 135
- SENSe:AVERage:STATe? 135
- SENSe:CORRection:COLLect:ZERO 136
- SENSe:FREQuency[:CONTinuous] 138
- SENSe:FREQuency:CONTinuous? 139
- SENSe:FREQuency:NCONtinuous 140
- SENSe:FREQuency:NCONtinuous? 140
- SENSe:POWer:RANGe? 141
- SENSe:POWer:RANGe:AUTO 142
- SENSe:POWer:RANGe:AUTO? 143
- SENSe:POWer:RANGe:HIGH 144
- SENSe:POWer:RANGe:LIST? 144
- SENSe:POWer:RANGe:LOW 145
- SENSe:POWer:REFerence 145
- SENSe:POWer:REFerence? 146
- SENSe:POWer:REFerence:DISPlay 146
- SENSe:POWer:REFerence:STATe 147
- SENSe:POWer:REFerence:STATe? 147
- SENSe:POWer:UNIT 148
- SENSe:POWer:UNIT? 148
- SENSe:POWer:WAVElength 149
- SENSe:POWer:WAVElength? 149
- TRACe:DATA? 150
- TRACe:POINts 151
- TRACe:POINts? 151
- TRIGger:SEQuence:LEVel 152
- TRIGger:SEQuence:LEVel? 153
- TRIGger:SEQuence:SLOPe 153
- TRIGger:SEQuence:SLOPe? 154
- TRIGger:SEQuence:SOURce 154
- TRIGger:SEQuence:SOURce? 155
- TRIGger:SEQuence:STATe 155
- TRIGger:SEQuence:STATe? 156
- UNIT:POWer 156
- High-Speed Power Meter 147 157
- High-Speed Power Meter 149 159
- High-Speed Power Meter 151 161
Související produkty a manuály pro Měřící nástroje Exfo PM-1600 High-Speed Power Meter
Měřící nástroje Exfo iOLM Uživatelský manuál
(186 stránky)
(186 stránky)
Měřící nástroje Exfo iOLM Uživatelský manuál
(181 stránky)
(181 stránky)
Měřící nástroje Exfo iOLM Uživatelský manuál
(188 stránky)
(188 stránky)
Měřící nástroje Exfo iOLM Uživatelský manuál
(188 stránky)
(188 stránky)
Měřící nástroje Exfo iOLM Uživatelský manuál
(183 stránky)
(183 stránky)
Měřící nástroje Exfo FG-750 Uživatelský manuál
(338 stránky)
(338 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.046 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce