Exfo VDSL2 Uživatelský manuál Strana 100

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 124
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 99
Running a VoIP Test
94 AXS-200/630
Reading Results
DSL Parameters
The DSL Params tab allows you to view the pass/fail status of the
DownStream and UpStream parameters configured in the test setup.
The available test results are the
following:
³ SNR Margin is a value ranging
from 0 through 63.5 for the
minimum signal-to-noise ratio
margin.
³ Attenuation is a value ranging
from 0 through 63.5 for the
maximum attenuation.
³ Output Power is the current transmit power level that is a measure of
the absolute transmit power.
³ INP is the level of impulse noise protection.
³ Interl.Depth is interleave depth which defines the number of bits (or
bytes) in each block of data.
³ Interl.Delay is interleave delay which defines the mapping (relative
spacing) between subsequent input bytes at the interleave input and
their placement in the bit stream at the interleave output.
³ Trellis or Trellis Coded Modulation (TCM) is a type of convolutional
code which utilizes parity bits on each symbol within a continuous
data stream. When the line is connected, Trellis displays either ON or
OFF.
³ BITSwap specifies the status of the bit swapping mechanism - Active,
Not
Active or Unknown - swapping bits from tone m to tone n to
prevent modem retraining.
Zobrazit stránku 99
1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 123 124

Komentáře k této Příručce

Žádné komentáře