Exfo VDSL2 Uživatelský manuál Strana 133
- Strana / 275
- Tabulka s obsahem
- ŘEŠENÍ PROBLÉMŮ
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
Wideband Tests
Copper, VDSL2, ADSL2+ and IP Triple-Play Test Set 125
Spectral Detective Test
Spectral Detective Test
The wideband spectral detective test allows you to bridge onto a live circuit
to measure the PSD noise of the line. The spectral detective test measures
up to 2.2 MHz (optionally up to 30 MHz with VDSL2WB option) so you can
determine the xDSL technology that is being transmitted over the line, and
the power associated with the transmitted technology to ensure it is not
disruptive to adjacent cables and technologies.
Test Setup
The Test Setup tab allows you to configure parameters for the wideband
spectral detective test.
Each parameter on the pane is
described below.
³ Bandwidth specifies the frequency
range for the test. Select 2.2 MHz,
12 MHz, 17 MHz, or 30 MHz.
Note: Frequency bands in excess of 2.2 MHz
are only displayed if VDSL2WB is
enabled in the software options.
³ Noise Filter defines the level of wideband noise filtering. The available
choices are: NONE, 50 kbit, ISDN-E, HDSL-F, ADSL-G, ADSL, ADSL2+,
VDSL, VDSL2-8, VDSL2-12, VDSL2-17, or VDSL2-30.
Note: VDSL2-x filters are only available if VDSL2WB is enabled in the software
options.
³ Termination Impedance defines the resistive impedance of the
dummy load connected to the line. Select one of the following:
100 or 135 Ohm.
- AXS-200/635i 1
- Contents 3
- Certification Information 6
- DECLARATION OF CONFORMITY 7
- 1 Introducing the Copper 9
- VDSL2, ADSL2+ and IP 9
- Triple-Play Test Set 9
- Typical Applications 11
- Cable Connections 12
- LED Indicators 13
- Electrical Safety Information 13
- ADSL2+ Basic Principles 14
- IMPORTANT 16
- 2 Getting Started with Fault 17
- Isolation Tools 17
- Dialer Function 18
- 12 AXS-200/635i 20
- Phone Book 21
- Regional Settings 23
- Cable Setup 25
- 18 AXS-200/635i 26
- Standard 27
- 22 AXS-200/635i 30
- Reading Saved Results 31
- 3Auto Tests 33
- Test List 1 34
- Configuring CQ Auto Tests 35
- Test List 2 36
- Common Parameters 37
- VF Test Parameters 38
- WB Test Parameters 40
- Thresholds 1 42
- Thresholds 2 44
- Multi-meter Results 46
- Metallic Insulation 46
- Load Coil 46
- VF Tests 47
- VF Impulse Noise 47
- Receive Tone 47
- WB Longitudinal Balance 48
- WB Impulse Noise 51
- 44 AXS-200/635i 52
- Inactive Pair Test 53
- Opens Meter 58
- Loop Mapper 59
- 52 AXS-200/635i 60
- Final/Active Pair Test 62
- Thresholds 3 66
- Result 1 68
- Result 2 68
- Video-DSL Rate Prediction 70
- Configuration 71
- 64 AXS-200/635i 72
- Impulse Noise Setup 74
- Viewing Results 76
- Video Rates 78
- Multi-meter Tests 79
- WB PSD Noise 81
- WB Attenuation 82
- DSL Rate Tests 83
- 76 AXS-200/635i 84
- 4 POTS Auto Test 87
- 80 AXS-200/635i 88
- 5 Multi-meter Tests 89
- Ground Resistance 91
- Resistance 91
- 84 AXS-200/635i 92
- Multi-meter 92
- Capacitance 94
- In Service 98
- Water Detection Test 99
- Resistive Balance 100
- 6VF Tests 103
- Receive Tone (RX) 104
- Send Tone (TX) 105
- Tracing Tone 106
- Noise Metallic 107
- Impulse Noise 108
- Power Influence 110
- Longitudinal Balance 111
- Load Coil Detection 111
- 7Fault Location 113
- TDR Test 114
- RFL Single Pair (2 wire) Test 116
- Connection Diagram 118
- Test Setup 119
- 112 AXS-200/635i 120
- Loop Mapper Test 122
- Result Summary 123
- TDR Graph 123
- 116 AXS-200/635i 124
- FDR Graph 125
- 8 Wideband Tests 127
- PSD Noise 130
- 124 AXS-200/635i 132
- Spectral Detective Test 133
- 126 AXS-200/635i 134
- Spectral Detective 135
- Impulse Noise Test 136
- Impulse Noise Result 137
- Impulse Noise Histogram 138
- 132 AXS-200/635i 140
- Attenuation Test 141
- Attenuation 142
- Longitudinal Balance Results 144
- Data Rate Prediction 145
- 138 AXS-200/635i 146
- 140 AXS-200/635i 148
- Signal-to-Noise Ratio 151
- Bits per Bin 152
- Ethernet Testing 153
- DSL/IP Tests Menu 154
- Saving Results 155
- Read Saved Results 157
- Setup Profile 159
- Selected Profile 160
- Setup Line Connection 163
- 156 AXS-200/635i 164
- WAN Access 165
- 158 AXS-200/635i 166
- LAN Setup 170
- Thresholds 172
- Triple-Play Verification 175
- Configure Profile 176
- Configure DSL/IP Tests 177
- 170 AXS-200/635i 178
- Ping Test 179
- TraceRoute 180
- HTTP Speed 181
- FTP Speed 182
- IPTV Analysis 183
- 176 AXS-200/635i 184
- VoIP Analysis 185
- Data Analysis 186
- STB Support 187
- 12 Running Manual Tests 189
- Line Status 190
- DSL Parameters 192
- Statistics 193
- VDSL Bands 194
- WAN Status 196
- HPNA Info 201
- HPNA Statistics 202
- 13 IPTV Analysis 203
- LAN Status 211
- Network Activity 212
- Down Stream Rate 212
- ERR Indicator 213
- IGMP Monitor 214
- RTSP Info 215
- Detected Streams 217
- IP Arrival Jitter 218
- PCR Jitter 219
- Stream Parameters 220
- Stream Content 221
- 14 Data Analysis 225
- IP Packets 233
- Protocols 234
- Down Stream Rates 235
- Up Stream Rates 235
- 15 Running a VoIP Test 239
- Call History 247
- Packets Analysis 248
- Jitter Analysis 249
- 16 Maintenance 253
- Recycling and Disposal 254
- 17 Troubleshooting 255
- AXS-635i-XX-XX-XX 256
- Transportation 257
- 18 Warranty 259
- Service and Repairs 261
- 254 AXS-200/635i 262
- A Technical Specifications 263
- Technical Specifications 264
- ₼⦌␂ℝ☀⹂䓸德棟Ⓟ䤓屓⸩ 273
- MARKING REQUIREMENTS 274
Související produkty a manuály pro Měřící nástroje Exfo VDSL2
(26 stránky)
(160 stránky)
(173 stránky)
(169 stránky)
(160 stránky)© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.037 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce